Add: A Building, Gangshen Innovation Park, No.40, Huaning Road, Dalang Street, Longhua District, Shenzhen China Contact: Jack Fu Phone: +8615814051091 E-mail:info@gpstrackingfactory.com
Mobile DVR for Car
The recorder is DC power supply; please attention the positive and negative polar. 2. The voltage is 8V~36V.Do not insert voltage that beyond this range. Under low voltage the recorder doesn’t work, under high voltage will be harm to the...
2CH,Front port is earphone port ,rear port connects to BNC connector. The output level: 1V - 2V
Compression
G.726 compression, 8KB/s speed
Alarm Input
8CH IO Alarm Input, 1CH AD input, pulse speed input; Support alarm linkage function
Alarm Output
2CH Relay Alarm Output, Support the linkage acousto-optic alarm, cut off fuel oil/power,etc
Communication Interface
1CH RS232, support extension device, such as POS machine, Oil Feul sensor, LED advertising screen , etc.
1CH 485 interface, can connect PTZ,etc.
Wireless transfer
Support Built-in 3G/4G network, WCDMA,CDMA2000,TDD-LTE,FDD-LTE...
Support Built-in/External WIFI,Compatible with GPRS,EDGE
Position
Support Built GPS/BD Module,can make playback analysis of vehicle routing
G-Sensor
Support G-sensor
Storage
2pieces SD Card,each max 128GB SD Card, mirror recording to protect data from loss
Instruction:
1. The recorder is DC power supply; please attention the positive and negative polar.
2. The voltage is 8V~36V.Do not insert voltage that beyond this range. Under low voltage the recorder doesn’t work, under high voltage will be harm to the recorder.
3. Please make sure the recorder is connect with the car power directly. Do not connect with the generator, the instantaneous voltage will harm to the recorder.
4. The initial power will beyond 30W when the DVR connect with the Camera (the consumed power is different due to the connect with different device), the power supply must beyond 30W.
5. The power cables must can stand beyond 60W.(For example, when the output voltage of car is 12V,the power cables must can bear 5A or more).
6. Please put the cover on the cables, the cover must be wear-resistant, heat-resistant, water-proof, grease-proof, in case of short circuit and open circuit.
7. Please install a 10A fuse box near the battery output positive polar for fear of the short circuit will damage the power supply.
User Loading
When the password switch is set to “Off”: The host start and press [OK] key, will direct access to the main menu..
When the password switch is set to “On”: Move the cursor to “landing” column, Press [OK] key, then can enter the main menu.